Loading...
> >

DForce Hair Help

nikijunpei81nikijunpei81 Posts: 44
in The Commons

Hello.  When i use dforce simulation something strange happens with the hair. How can i preserve curly shape of them in simulation?

The hair is this

The pics shows what hair appears before simulation and after. Settings used are default setting.

Thank you

test01.png
773 x 860 - 370K
test02.png
773 x 860 - 367K

Comments

  • chevybabe25chevybabe25 Posts: 1,265

    dForce hair is a fickle pain.  If the hair has too many points, its going to melt when you run a simulation.  If it doesnt have enough points, it will refuse to drop at all. 

    My advice is to reduce the amount of ps/ pr points on all the surfaces.  If it's set to 30, drop it to 20 etc.   With the new curves, it doesnt need to be set super high.

  • crosswindcrosswind Posts: 7,142
    edited September 24

    Select the hair, go to Surfaces pane, filter out Local Shape Constraint Stiffness property, set its value > 0.5

    Default value is 0.9, the vendor set it too low (0.1) ... so the natural curly shape cannot be preserved while draping ...

    SNAG-2024-9-25-010.png
    2560 x 1392 - 1M
    Post edited by crosswind on
  • nikijunpei81nikijunpei81 Posts: 44

    Really thank you

Sign In or Register to comment.