Loading...
> >

Why the dforce of a plane behave like this?

JamesJames Posts: 1,025
in Daz Studio Discussion

I have a  plane as a blanket.
I added Dforce.
I rotate it to shift a bit.
But when I simulate, why it is instead of falling down, it fall to the lowest point, as if it slides.

Comments

  • crosswindcrosswind Posts: 6,926
    edited September 23

    How many divisions did you give the plane primitive ? If there's not enough divisions set for the mesh to well drape, you may see such issue like "sliding".

    A good result of a draping blanket should come from setting enough divisions as well as the properties on its dynamic surface. (ss3)

    SNAG-2024-9-23-020.png
    2560 x 1392 - 911K
    SNAG-2024-9-23-019.png
    2560 x 1392 - 749K
    SNAG-2024-9-23-021.png
    2560 x 1392 - 1M
    Post edited by crosswind on
  • JamesJames Posts: 1,025
    edited September 23

    1m2, 50subs

    Post edited by James on
  • Olo_OrdinaireOlo_Ordinaire Posts: 742

    You may also want to check the Environment setting for Air Resistance in the Simulation pane..  It doesn't take much above the default value for a tilted plane to slide toward the lowest point during simulation.

    I sometimes set Gravity to 2.0, the maximum value, when I want to simulate more quickly or force the object to conform better.

  • crosswindcrosswind Posts: 6,926

    James said:

    1m2, 50subs

     50 subs ? what do you mean by subs ? SubD?  You couldn't get a 50 SubD... If it was 50 Divisions, it should be enough ~ Screenshots ?

Sign In or Register to comment.