Loading...
> >

Kinda Basics... but...

evilded777evilded777 Posts: 2,464
edited April 15 in Hexagon Discussion

I've got an obj that's a pair of shoes. I'm trying to use Studio/Hexagon bridge to get them to line up with Genesis 8 Male so I can use the Transfer Utility.

Problem is, they are a pair in a single OBJ, so I can't manipulate each shoe into position seperately.

Is there a way to either split these into seperate objects and then re-group them after I have postioned them? Any advice or suggestions appreciated.

I've already done this with a model that was already seperate.

HexCapture.JPG
1058 x 691 - 57K
Post edited by evilded777 on

Comments

  • Richard HaseltineRichard Haseltine Posts: 100,732

    Can't you just marquee select them and stransform them or cut-and-paste them to a new object layer?

  • FirstBastionFirstBastion Posts: 7,760

    Treat each shoe as its own model, Left and right,

  • evilded777evilded777 Posts: 2,464

    Richard Haseltine said:

    Can't you just marquee select them and stransform them or cut-and-paste them to a new object layer?

    Not sure what you mean here

    Solved the issue by learning to use dformers and weight maps, but thanks for the response.

  • evilded777evilded777 Posts: 2,464

    FirstBastion said:

    Treat each shoe as its own model, Left and right,

    I didn't make the model, this is how it came...but I figured a way around it. Thanks for the response.

  • Richard HaseltineRichard Haseltine Posts: 100,732

    evilded777 said:

    Richard Haseltine said:

    Can't you just marquee select them and stransform them or cut-and-paste them to a new object layer?

    Not sure what you mean here

    Solved the issue by learning to use dformers and weight maps, but thanks for the response.

    marquee select I meant - drag a rectangle out to select all inside it, then transform or cut-and-paste to a new layer the selected bits

Sign In or Register to comment.