Loading...
> >

FYI: Daz characters need to be resized a bit

rsharprsharp Posts: 45
edited October 2021 in Blender Discussion

I only have Cleopatra 8.1 and from its product page, the character is supposed to be 5' 4" (162.5 cm).   And I confirmed this in Daz by creating a 100 inch cube and scaling the Y value to 64%

After importing into blender via the bridge, I found I needed to scale the character by a factor of 1.1 x to be 5' 4".   Otherwise it was just under 4' 10"

So not sure if all characters are also coming across smaller, or this is unique to Cleopatra or some kind of settings.  The character is in its default form and in the default A-pose.

I suppose this could also be a bug in Daz, but hopefully not (i.e. then one couldn't trust any size settings there).

Post edited by rsharp on

Comments

  • Silver DolphinSilver Dolphin Posts: 1,607

    This is the bane of 3D everyone has their own standard because they don't want to share. If the standard was opensorce and everyone used the same size it would be easier on us consumers but corporations are all about exclusivity and owning everything. Consequently, you are gonna run into these problems.

  • brainmuffinbrainmuffin Posts: 1,204

    DAZ characters aren't the only one. I've downloaded a few from Mixamo. One character will be 12 feet tall, while another is 6 inches. I agree with Silver Dolphin: too many don't want to play nice.

Sign In or Register to comment.