Loading...
> >

I must be screwing up my Bryce 7 PRO installation... or???

helenofpeel_e269dcdfcahelenofpeel_e269dcdfca Posts: 3
edited December 1969 in Bryce Discussion

Hello all,

I've been running Bryce 7 PLE for quite a while. Yesterday I bought Bryce 7 PRO and downloaded the installs.
The strange thing is, after install I am still getting Bryce 7 PLE on startup.
What am I doing wrong?

When I went to install Bryce 7 PRO, it asked to uninstall PLE, which seems the right thing to do.
Then it went ahead with PRO installation and seemed fine.
I then clicked on the Bryce icon and the program boots up as PLE.

Help!

Any suggestions welcome!

Helen

Comments

  • fixmypcmikefixmypcmike Posts: 19,585
    edited December 1969

    You need to enter the Pro serial number.

  • helenofpeel_e269dcdfcahelenofpeel_e269dcdfca Posts: 3
    edited February 2015

    Well I would if I had it. But as you can see, it's not on my receipt!

    Post edited by helenofpeel_e269dcdfca on
  • helenofpeel_e269dcdfcahelenofpeel_e269dcdfca Posts: 3
    edited February 2015

    ....

    Post edited by helenofpeel_e269dcdfca on
  • helenofpeel_e269dcdfcahelenofpeel_e269dcdfca Posts: 3
    edited December 1969

    Scratch that. I found it.

    Thanks!

  • namffuaknamffuak Posts: 4,154
    edited February 2015

    Click on the little 'dot on a lump' icon top right, on the home page or any store page; from the drop-down box that appears click on 'My Account'. Then click on 'Serial Numbers'. You should see an entry for Hexagon 2.5.

    Hexagon seems to be a bit finicky; I tried pasting mine in a couple of times and finally had to just type it in to make it work.

    ETA:
    Apologies for those who read this later, since you found what you needed. I just built a new system and re-installed everything and had Hexagon on my mind - for 'Hexagon' in the first two paragraphs read 'Bryce' and it will show up as 'Bryce 7 Pro' in the serial numbers.

    Post edited by namffuak on
  • HoroHoro Posts: 10,709
    edited December 1969

    Bryce 7.1 PLE and Bryce 7.1 Pro are the same programs. PLE (personal learning edition) has a couple of options inhibited and they can be enabled by entering the Pro serial, then quit and restart Bryce and you have the Pro version running.

Sign In or Register to comment.