Loading...
> >

I need a little help

GreycatGreycat Posts: 334
in Hexagon Discussion

I remember something where you held a key down and clicked on a line. the line was deleted and the two adjacent surfaces became one surface. I hope someone can help.

Comments

  • AscaniaAscania Posts: 1,853

    Are you talking about Target Weld?

  • GreycatGreycat Posts: 334

    no

  • AscaniaAscania Posts: 1,853

    Then you're talking about Backspace.

  • GreycatGreycat Posts: 334

    That maybe right

  • GreycatGreycat Posts: 334

    nope that's not it.

    C hannel.jpg
    498 x 805 - 69K
  • GreycatGreycat Posts: 334

    I take back, that is it. Thanks

  • Wee Dangerous JohnWee Dangerous John Posts: 1,605
    edited March 2021

    Ascania is right, it is the Dissolve Vertices tool you used.

    Not wanting you to go to far with your model, you are going to run into problems with the approach you have taken - Ngons (Selection, Select non 4 point faces).

    I recreated your model (using quick extrude and symmetry) and took a few screen grabs.

     

    extrude.jpg
    1918 x 976 - 612K
    Post edited by Wee Dangerous John on
Sign In or Register to comment.