Loading...
> >

carpet

laverdet_943f1f7da1laverdet_943f1f7da1 Posts: 252
edited December 1969 in Carrara Discussion

Hello everybody!
I have that problem: a carpet, draped on a round shape, and a part of it going on the ground, and so, flat... in other words, the same geometry on a cylinder, and a part going flat...
there is a repetitive pattern on the carpet... HOW to do, to get an uv map usable for the whome carpet, part round, part flat, with no deformation of the pattern???? thank you for helping!!

Comments

  • WendyLuvsCatzWendyLuvsCatz Posts: 38,219
    edited December 1969

    go into the vertex room, select all and open the uv tab and see how it fits, then relax it and drag bits around to make it fit how you wish.

Sign In or Register to comment.